Sunsystem BURNiT Pell 300 Mega, Технический паспорт, руководство по установке и эксплуатации, Страница: 19 / 32

19
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
9.2.2. Burner star up "Switch mode"
Burner start-up.
After pressing the
“F” button and
using the „navi-
gation arrows”, the
“Auto” menu is selected. Pressing the "F"
button will open the next page of the
menu.
Set the priority mode of the burner
through "navigation arrows."
Set the priority
mode of the burner
through “navigation
arrows.”
- CH + DHW – Both pumps / CH -central
heating pump and DHW – domestic
hot water pump /are active.
- CH only – In this mode of operation the
only active pump is the CH circulation
pump for the heating installation (CH
pump) . In this mode, the boiler can
be managed via a room thermostat
or be temperature-controlled by the
temperature inside the connected
buffer tank to it (depending on the
connection scheme)
(see item 10.3.4,
menu CH Mode).
- Summer Mode – Summer mode. Boiler
works for heating of domestic hot water
only.
If you have selected
the (CH + DHW)
option, upon
confirmation of
command via the "F" button you may
navigate to the next screen.
From this menu
you can set up and
adjust DHW pump
activity periods. Use the arrow keys to
set time (HH:MM) . Use “Enter” button to
checkmark desired time period option.
If no option is check-marked,
the controller will maintain DHW
temperature as a priority. Only when
its preset value is reached, the CH
circulation pump will start.
9.2.3. Burner shut-down "Standby"
Pressing the “ F ”
button will take you
to the main menu
and by using the
navigation arrows
you can select the “ Standby ” menu and
confirm the selection by pressing “ F ”.
The burner goes into extinguishing mode.
9.3. Installer's menu (setting the
combustion parameters in the burner
controller)
CAUTION! We recommend that
this menu be used only by an
authorized installer/service
shop in order to ensure efficient
and safe operation of the
equipment
To access the
s e t t i n g s
a d j u s t m e n t
m o d e ,
simultaneously
press the “Enter” and „ F ” buttons and
hold them pressed for 4 / four / seconds.
This will display the controller hardware
and software version on the screen. Press
again button “Enter” and this will open
the initial page for the burner settings.
For access to service settings menu you
need a service menu code.