© by WilTec Wildanger Technik GmbH
Seite 26
http://www.wiltec.de
http://www.aoyue.eu
http://www.teichtip.de
Version 6. 2017
Note:
Installation
The Pump has to be installed under water. Make sure that moisture or water never reaches the
mains connection.
The pump is to be installed as follows: in a fixed position with fixed or flexible hose.
Take care, that there are no bubbles in the hoses.
Immerse the pump into the pond water (min 20cm), so that it is filled with water.
To avoid the premature clogging of the filter, position the pump above the pond sludge.
Install the supplied filter sponge to keep the pump inlet free.
The pump is started by plugging in the mains plug.
Commissioning
After reading the installation instructions carefully, you can start the new pump if you note the fol-
lowing aspects:
•
Connect the rubber feet with the Motor Body and Filter Basket.
•
Check if the pressure pipes have been installed properly.
•
Make sure that the electrical connection is 230V~50Hz.
•
Check if the socket is in proper working order.
•
Make sure that moisture or water never reaches the mains connection.
•
Install the Pump under the Water surface.
•
Avoid that the pump operates dry.