Explosion view and parts list
№ Name
№ Name
1
Filter basket
11
Air inlet plug
2
Filter sponge
12
Engin housing
3
Large filter sponge
13
O-ring
4
Connector
14
Axe
5
Controller
15
Rotor
6
Air inlet
16
Bearing
7
Outlet
17
Pump housing
8
Air inlet
18
Guiding
9
Supply line
19
Suction cup
10
Valve air inlet
Cleaning
Disconnect the pump from the power supply and remove it from the water. By pulling and
moving carefully separate the engine housing from the impeller chamber. Remove the impeller
and the shaft and clean them with a brush. You can remove resistant debris by putting these
parts in vinegar. Please rinse the parts thoroughly before you put them back into the pump.
The plastic bearings, the ceramic shaft and the like are wear parts. If, despite regular cleaning,
the pump generates significant operating noise after prolonged operation, it may be useful to
replace these parts.
Please clean the sponge regularly in order to avoid an impact on the pump performance.
© by WilTec Wildanger Technik GmbH
Item 50325–50327
Page 5
http://www.WilTec.de
http://www.aoyue.eu
01 2021
-1