SUNSTONE Orion M Series, Руководство пользователя, Страница: 8 / 20

m Series User Manual
8
•
Loosen/tighten the allen on the microscope arm to adjust the spring
pressure . Turn the allen clockwise if the arm does not hold the microscope
up . Turn the allen counter clockwise if the arm does not allow the
microscope to come down .
ADJUST WELDING STYLUS POSITION
•
Loosen the screws on either side of the stylus holder .
•
Adjust the welding stylus to a 45-degree angle then slightly tighten the
screws on the sides just enough to hold the stylus in place at a 45-degree
angle .
•
While looking through the microscope, slide the welding stylus forward
and backward until the tip of the stylus is in the center of your focus .
•
Now securely tighten the stylus holder by tightening the screw on the
bottom of the stylus holder .
ADJUST THE MICROSCOPE FOCUS
•
Twist the knob on the microscope forward and backward to raise and
lower the head . This will allow you to focus the microscope on the welding
stylus .
•
Place your finger under the welding electrode to help judge the correct
focus location . Focus the microscope until the texture on the skin of your
finger is clearly visible .
Microscope LCD Filter Shutter
The microscope LCD filter shutter allows an unobstructed working view before welding and completely protects the user’s
eyes during the welding process . The Orion’s internal computer verifies the microscope LCD filter shutter has been closed
before allowing the weld to take place . In the case that the shutter does not close, the microscope lens is equipped with >UV
16 and >IR 16 for maximum eye protection .