SUNSTONE Orion M Series, Руководство пользователя, Страница: 5 / 20

5 OrionWelders.com
Chapter 1: Welder Setup & Assembly
What is in the Box
ALL ORION M SERIES SYSTEMS COME WITH:
(1) Orion mPulse Welder/Power Supply and
Stylus Hand Piece
(1) Orion mPulse Welder Power Cord (2 pieces)
(2) Alligator Clips
(1) Shielding Gas Hose
(1) Electrode Vile (5 – 0 .5mm and 5 – 1 .0mm
Electrodes)
(1) Fiberglass Brush
IF YOU PURCHASED THE DARKENING LENS SYSTEM:
(1) Darkening Lens Stand with attached RJ45 Cable
IF YOU PURCHASED THE MICROSCOPE ARM SYSTEM:
(1) Orion Microscope Arm
(1) Microscope Arm Table Mount
(1) Microscope Arm Support Bar
Darkening Lens & Power Supply Setup
SET UP THE BACK SIDE OF THE POWER SUPPLY
The Orion has an internal switching power supply that can accept both 120 and 240VAC .
The darkening lens or microscope will automatically darken when the weld takes place . This allows the user to have a view of
the work-piece and protection from the flash during the welding process .
Remove the welder and Darkening Lens from the box and place
them on the table .
1.
Plug the female end of the power cable into the AC Power
port on the back of the power supply . Then connect the
male end into AC power .
2.
Insert the 1/4” gas tube firmly into the “Gas” port on the
back of the welder . *It may wiggle when connected, but
should not come out if pulled on .
3.
Insert the RJ45 Darkening Lens cable (from the back of
the darkening lens) into the ACC port on the back of the
welder .
4.
Plug the alligator clip into the positive port . *Remember to
attach the alligator clip to the work-piece before welding .
1 . 2 .
4 .
3 .
7 .