107
MANUAL CUTTING
When the operating system loads, press and the following screen will appear:
OFFSET SET-UP
OFFSET IS USED WHEN SEWING APPLIQUES
Press when the operating system loads and the following screen will appear:
This function returns the frame to the point assigned by the user at the start and
end of the embroidery operation. This function can come in handy when changing
the frame or arranging the cloth. The following 4 set-up items must be entered:
1) START POINT: (Embroidery starting point) Assign the point to start the embroidery work.
2) MIDDLE OFFSET: (Middle point of the offset) To prevent accidents from occurring as the frame
moves onto the offset point, assign a midway point.
3) OFFSET POINT: Assign the point the frame should automatically move to when the frame has reached
the offset point assigned in the needle bar setup. (See Needle Bar Set-up Page 109).
4) At (needle bar set-up) enter CL at the desired offset point.
This function is used to trim during the embroidery operation. If the START SWITCH is pressed when the
above screen appears, trimming is performed automatically.
Press (PREVIOUS) to cancel.
TRIMMING OPERATION
RUN => START SWITCH
CANCEL => PREVIOUS
===
START POINT
===
=> FRAME MOVE