SunStar CK18T-4-LP, Инструкция по установке и эксплуатации

Страница: 6 / 16

-5-
SPECIFICATIONS
Model SC18T-1-NG Model SC18T-1-LP Model SC30T-1-NG Model SC30T-1-LP
BTU/HR Input
Type Gas
Ignition Type
Temp. Control
Weight
Heater
Shipping
Inlet Gas Pressure
Maximum
Minimum
Regulator Setting
Dimensions (inches)
Heater (W x D x H)
Carton
18,000
Natural Gas
Piezo ignitor
Manual
20 lb.
24 lb.
14.0" W.C.
7.0" W.C.
6.0" W.C.
19-3/4 x 9-1/2 x 25
21-1/2 x 10 x 25 1/2 16,500
LP Gas
Piezo ignitor
Manual
20 lb.
24 lb.
14.0" W.C.
11.0" W.C.
10.0" W.C.
19-3/4 x 9-1/2 x 25
21-1/2 x 10 x 25 1/2 30,000
Natural Gas
Piezo ignitor
Manual
27 lb.
32 lb.
14.0" W.C.
7.0" W.C.
6.0" W.C.
27 1/2 x 9-1/2 x 25
29 x 10 x 25 1/2 27,000
LP Gas
Piezo ignitor
Manual
27 lb.
32 lb.
14.0" W.C.
11.0" W.C.
10.0" W.C.
27 1/2 x 9-1/2 x 25
29 x 10 x 25 1/2
CLEARANCES
You must provide adequate clearance around air openings to the heater. You also must provide for an adequate combustion
and ventilation air supply to the space to be heated. The heater must be easily accessible for servicing. The opening for
combustion air located at the bottom of the heater must not be obstructed.
The heater must be installed no less than 2" above the top surface of carpeting, tile or other floor covering. When facing the
front of the heater, the clearance from any combustible materials must be a minimum of 13" from the left, 13" from the right,
36" from the top, and 2" from the bottom.
Never install the heater in front of any flammable object, especially do not place curtains, furniture, clothing or other flammable
objects less than 36” from the front of the heater.
FLOOR MOUNT INSTALLATION (When using the optional legs for Models SC18T and SC30T)
This heater is designed to be installed on the floor with the leg set that is included with each heater.
Locate the leg set and attach the legs to the heater as noted on Page 10. Screw in elbow A and B with sealing tape as shown in
Figure 1 below.
Fig ure 1
A
B
If this heater is to be installed directly on carpeting, tile or other combustible material other than wood flooring, the heater shall
be installed on a metal or wood panel extending the full width and depth of the heater. All other clearances to combustible
materials stated above must be maintained. Floor protection panels (PN 44058010) are available as an accessory.
The panel referred to above does not mean the fireproof base as used on wood stoves. The protection is for rugs that are
extremely thick and light-colored tile that may discolor and to make sure the heater is level.