Instruction Manual
Pediatric
Compressor
Nebulizer
NEB300BASKETBALL
NEB300BASKETBALL-R
NEB300BASKETBALL-IFU V 1.01
2020-09-03
Deluxe Nasal Pillow CPAP Mask
Item#
CM036
Intended Use
The nasal pillow mask is intended to provide an interface for Continuous Positive Airway Pressure (CPAP) or bilevel system.
The mask to be used by adult patients (>66lb/30kg) for whom positive airway pressure has been prescribed. The mask is for
single-patient re-use in the home environment and multi-patient re-use in the hospital/institutional environment.
Caution
US federal law restricts this device to sale by or on the order of a physician.
Excluding patient population
This mask may not be suitable for patients with the following conditions: impaired cardiac sphincter function, excessive
reflux, impaired cough reflex and hiatal hernia. It should not be used if the patient is unresponsive, obtunded, unable to
remove the mask, or uncooperative.
Warnings
This mask is designed for use with CPAP or bilevel systems recommended by your health care professional or respiratory
therapist. Do not wear this mask unless the CPAP or bilevel system is turned on and operating properly. Do not block or try
to seal the exhalation port.
CPAP systems are intended to be used with special masks with connectors which have vent holes to allow continuous flow of air out of the mask. When the
device is turned on and functioning properly, new air from the device flushes the exhaled air out through the attached mask exhalation port. However, when
the device is not operating, enough fresh air will not be provided through the mask, and exhaled air may be re-breathed. At low pressures, the airflow through
the exhalation port may not be enough to clear all of the exhaled gas (CO2) from the mask. You may breathe in some of the air that you have exhaled.
If oxygen is used with the device, the oxygen flow must be turned off when the device is not operating.
• When the device is not in operation, and the oxygen flow is left on, oxygen delivered into the ventilator tubing may accumulate within the device enclosure.
Oxygen accumulated in the device enclosure will create a risk of fire.
• Oxygen supports combustion. Oxygen should not be used while smoking or in the presence of an open flame.
• At a fixed flow rate of supplemental oxygen flow, the inhaled oxygen concentration will vary, depending on the pressure settings, patient breathing pattern,
nasal interface selection, and the leak rate.
Some users may experience skin redness. If this happens, contact your health care professional.
Cleaning the Mask
The cushion, nasal interface, and tubing should be cleaned daily or as needed.
• Hand wash in warm water with a mild liquid dishwashing detergent. Do not use bleach, alcohol, or cleaning solutions
containing alcohol. Do not use cleaners containing conditioners or moisturizers.
• Rinse thoroughly. Pat with a towel and air dry completely before use
• Inspect all parts for damage or wear; replace if necessary.
Cleaning the Headgear
Hand wash the headgear weekly or as needed. Lay the headgear flat or line dry.
Disposal
The nasal pillow mask does not contain any hazardous substances and may be disposed of with your normal
household refuse.
latex
free
Manufactured for
Sunset Healthcare Solutions
180 N Michigan Ave Ste 2000
Chicago, IL 60601
SunsetHCS.com
DO NOT PRINT THIS LAYER.
100%
1 Color
1
PH 2.23.17
A4 (210mm x 297mm)
res036-ifu.pdf
When printing with default
Acrobat autoscale settings.
Cleaning
Cleaning of the compressor
Use a clean dry cloth and mild detergents to clean the outside of
the unit.
ATTENTION
During cleaning, make sure the internal parts of the unit
are not in contact with liquids and the power cord is disconnected.
Cleaning and disinfection of the accessories
After each use, disassemble and wash all nebulizer kit parts except the
long thin air tubing tubing in warm soapy water and rinse well, shake off
excess water and allow to air dry (do not towel dry). Never immerse the
long thin air tubing in water.
Do not boil or autoclave angled mouthpieces, air tubes, or masks.
It is important that the cleaning instructions are carefully
followed to ensure optimal operation.
Replacement of Nebulizer Kit
RES2210 Pediatric Aerosol Mask
(Included in NEB300BASKETBALL and NEB300BASKETBALL -R)
The pediatric aerosol mask should be replaced after a long period of
inactivity, or if it is obstructed by dry medication, dust, etc. With normal
use, the pediatric aerosol mask should last 1 month.
RES091 Disposable Nebulizer Kit
with Clear Tubing
(Included in NEB300BASKETBALL and NEB300BASKETBALL -R)
The disposable nebulizer T-Piece kit should be replaced after a long
period of inactivity, or if it is obstructed by dry medication, dust,etc. With
normal use, the disposable nebulizer T-piece kit should last 1 month.
RES093 Reusable Nebulizer Kit
with Green Tubing
(Included in NEB300BASKETBALL -R)
The reusable nebulizer T-Piece kit should be replaced after a long period
of inactivity, or if it is obstructed by dry medication, dust, etc. With
normal use, the reusable nebulizer T-piece kit should last 6 months.
Replacement of the filter
The filter is to be replaced after approximately 30 hours of use, or when
it appears dirty. Open the filter holder to replace the filter with a new
one. Use Sunset BF018 Nebulizer Filters.
Do not use the device without the filter.
Maintenance and Repair
Never open the device. There are no serviceable parts within the unit.
The compressor does not require lubrication or maintenance.
Troubleshooting
Symptom
Probable Cause
Solution
Noisy operation
No filter in the unit.
Put a filter in the unit.
Nebulizer does
not run or
nebulization is
weak
Nebulizer power
switch is off.
Turn nebulizer power
switch on.
Plug is loose.
Make sure the plug is
firmly inserted into the
electrical outlet.
Operating for longer
than the nebulizer is
designed to operate
Make sure the device has
been operating within
the indicated limits:
30 minutes ON/
30 minutes OFF.
Nebulizer kit nozzle
or other parts are
obstructed
Clean the nebulizer kit.
Air tube is bent
or not connected
firmly.
Remove any bends or
kinks in the air tube.
Make sure the ends of
the air tube are fitted
tightly onto the main
unit and onto the
nebulizer.
The filter is clogged. Replace the filter.
Medicine cup is
empty or overfilled.
Use the appropriate
amount of medicine
prescribed by your
physician to the medicine
container.
The medicine cup
cap or baffle is
loose.
Reattach the medicine
cup cap and make sure
the baffle is inserted
properly. See diagrams.
There is conden-
sation in the air
tube
Medication has been
overfilled
Adjust the amount of
medicine in the medicine
container to the appro-
priate level, connect
the air tube to the air
compressor, and turn the
unit on.
The nebulizer kit
was washed but not
dried.
Open and close the
nebulizer kit
repeatedly until the drops
disappear.
