ww w. icpsolar .com
B
A
T
T
E
R
Y
GOOD
OK
LOW
VERY LOW
CHARGED
CHARGING
(BAR-GRAPH OFF)
DIGITAL SOLAR POWER
CONTROLLER / CHARGER
CC20000D
BATTERY VOLTAGE
ARRAY CURRENT
CHARGE SET-POINT
BATTERY VOLTAGE
BATTERY AND
ARRAY FUSE
ON BACK
UNIT MAY
BE WARM
DURING
OPERATION
mo
c.r
al
osi
es
nu
s.
w
w
w
PRODUCT DESCRIPTION
SolarCharger 4000:
1 Sunsei™ Solar Module 4A, 16.5V (65W)
1 Power cable, AWG12 gauge, 10 feet
4 Standard stainless steel “S” mount brackets,
with accessories
SolarCharger 6000:
1 Sunsei™ Solar Module 6A, 16.5V (100W)
1 Power cable, AW G12 gauge, 10 feet
4 Standard stainless steel “S” mount brackets,
with accessories
SolarCharger 8000:
1 Sunsei™ Solar Module 8A, 16.5V (130W)
1 Power cable, AWG12 gauge, 10 feet
6 Standard stainless steel “S” mount brackets,
with accessories
Important Note:
It is essential to use a Sunsei™ Charge
Controller with the SolarCharger 4000/6000/8000 to protect
your battery from overcharging and optimize the charging
process.
CC10000: Two-step charging, overcharge protection; used in
systems up to 10A capacity (150W).
CC20000D: Overcharge protection; used in systems up to
20A capacity (300W) with digital LCD for voltage and current
outputs & LED battery condition indicator.
CC25000: Two-step charging, overcharge protection; used
in systems up to 25A capacity (390W) with battery voltage
indicator and reverse polarity protection.
If the vendor from whom you have purchased this solar
panel does not carry Sunsei™ Charge Controllers, please visit
www.sunseisolar.com for a dealer near you.
SOLAR
CHARGER
4000/6000/8000
Operating Instructions
Register your warranty online
and enter to win an ICP Solar product.
www.icpsolar.com/warranty
“S” mount brackets
Power cable
SolarCharger
Sunsei™ Charge Controllers
(available for purchase separately):
Charge Controller
IMPORTANT!
Please read the instructions before operating.
• When working around batteries and other electrical equip-
ment, please observe industry standard and manufacturer’s
safety procedures.
• Install solar charger in low light conditions to reduce the risk
of electrical sparking.
• Make connections in a well-ventilated area free from
flammable gases or vapors.
• For 12V systems, ALL connections should be in PARALLEL:
Positive (+) to Positive (+), Negative (-) to Negative (-).
• DO NOT attempt to recharge NON-RECHARGEABLE
batteries.
• Always CONNECT the charge controller to the battery FIRST.
• When disconnecting your solar panel DISCONNECT the
battery LAST.
• Do not connect the solar panel directly to the battery
without using a Sunsei™ Charge Controller.
• Fuse wires extending from the battery to protect against
battery short circuits.
