10
Sedeo Ergo Rev.1.0
EN
GLISH
4.3 Preset Leg Lower Leg Length (standard Sedeo Ergo)
WARNING!
•
Be aware of your environment to make sure you do not injure your
legs when Leg Rests are extended.
•
Always ensure that the Leg Rests or foot plates do not come into
contact with the casters before driving the wheelchair.
•
Leg Rests are not to be used for lifting or carrying the wheelchair
under any circumstances.
•
As with all moving parts be careful not to trap your fingers,
(Fig.4.7).
Pre-set foot plate height and angle
The power centre mount footrest allows angle adjustment from 90°
to 180° level to ground and a 185 mm powered length extension.
The left and right footplate can be adjusted by an angle of +/- 5.0°
and has a mechanical height range adjustment of 200 mm to 460
mm measured from the footplate to the seat pan.
Pre-set foot plate height:
•
Undo the 2 bolts with a 5.0 mm Allen key, (A-Fig.4.8).
•
Slide the footplate receiver up or down to the height required.
•
Tighten the 2 bolts securely.
•
Repeat for the other side.
Pre-set foot plate angle:
•
Flip up the footplate so that you can reach the angle setting screw,
(B-Fig.4.9).
•
Use a 4.0 mm Allen key to adjust the bolt in or out depending on
the angle required.
WARNING!
•
After adjustment and with the seat in its normal drive position:
Ensure there Is a gap of, (>25 mm.), between the floor and the
footplate at all times when maneuvering the Foot plate up or down.
•
Perform this test with the user sitting in the chair loading the leg
rest.
Using the chair with the leg rest set too low might result in personal
injury or damage to the wheelchair and its surroundings.
1m
Fig. 4.7
B
Fig. 4.9
1000 mm
Fig. 4.8
A
Содержание QUICKIE Sedeo Ergo
Страница 75: ...75 Sedeo Ergo Rev 1 0...
