MK-100084 Rev. A
18
Q UI C KI E 7 R
L.
BACK ANGLE PERFORMANCE
Adjusting the Angle of the Backrest
1.
Release the backrest by pulling the adjustable tension pull cord (A) with a simple, short force.
2.
While maintaining tension on the release cord, rotate the backrest to the desired angle, either forward or
rearward.
3.
Lock the backrest in place by releasing the cord and allowing the pins (B) to engage in the nearest hole
(C) of the backrest bracket (D).
Folding and Unfolding the Backrest
1.
Release the backrest by pulling the adjustable tension pull cord (A) with a simple, short force.
2.
While maintaining tension on the release cord, rotate the backrest to unfold it. Remove the cushion and
push down hard to lock it in the folded position.
3.
Lock the backrest in the folded position by removing your cushion. Release the pull-cord, and push down
hard allowing the pins (B) to engage in the folded position hole (E) of the backrest bracket (D).
WARNING
Be sure the pins (B) are fully engaged through the backrest bracket (D) on both sides of the chair,.
Test the backrest to be sure it is locked before use.
M. TENSION ADJUSTABLE UPHOLSTERY
Installing standard Tension Adjustable Backrest Upholstery
1. Slide Velcro
®
straps (F) over the backrest frame (G) section. Make sure to include at least one
strap below the towel bar (if using a rigid chair).
2. Tighten the straps appropriately to desired tension level. DO NOT over tighten straps as this
will cause undue strain upon the chair backrest frame (G).
3. If using fold down push handles, insert the single Velcro
®
strap (F) through the slots in the
front of the push handles ( I ).
If using integral push handles ( J ), slide straps from bottom of backrest upward.
4. Install backrest cover at desired level and fold over rear of Velcro
®
strapping system (K). The
Quickie patch should be upright on the rear of the chair.
5. Finish installation by placing vanity flap (center panel) down onto Velcro
®
on the seat sling to
secure attachment (L).
WARNING
Any changes made to the straps will affect the center of gravity. It is best to have the attendant sta-
tioned behind the wheelchair to prevent the wheelchair from tipping backwards while the user
becomes accustomed to the adjustment.
24
23
22
21
20
19
VIII. USE AND MAINTENANCE
22
23
21
24
K
F
I
G
H
J
F
L
20
D
B
E
C
19
A
