6. Factory Reset Manually
Step 1
: Short press the “program” button 5 times continuously, the outlet will be reset to factory default and enter
into network pairing mode.
8. Find and Bind Mode
Step 1
: Short press “Prog.” button 3 times to start Find and Bind mode (LED indicator flashes slowly) to
find and bind target node, 180 seconds timeout, repeat the operation.
Step 1
: Short press the program button 4 times to start TouchLink Commissioning, 180 seconds timeout, repeat
the operation.
7. Factory Reset
through
a
Zigbee
Remote (Touch Reset)
Note
: Make sure the device already added to a network, the remote added to the same one or not added to any
network.
Step 2
: LED indicator will flash 3 times
slowly and then flahs fast and the
outlet will try to join a Zigbee network.
9. Learning to a Zigbee Green Power Switch
Step 2:
Set the green power
switch into Learning mode,
please refer to its manual
.
Zigbee
Green Power
Switch
Step 3
: LED indicator will
flash twice to indicate
successful learning. Then
the switch can control the
device.
Step 1
: Short press “Program” button 4 times to start Learning to GP switch mode (LED indicator flashes twice),
180 seconds timeout, repeat the operation.
Note: Each device can learn to
max. 20 zigbee green power switches.
10. Delete Learning to a Zigbee Green Power Switch
Step 2:
Set the paired green power switch into
Learning mode, please refer to its manual
.
Zigbee
Green Power
Switch
Step 3
: LED indicator will
flash 4 times to indicate
successful deleting.
Step 1
: Short press “Program” button 3 times to start delete Learning to GP switch mode (LED indicator flashes
slowly), 180 seconds timeout, repeat the operation.
Step 4
: There shall be indication
on the remote for successful reset
and LED indicator of the outlet will
flash 3 times.
5. Removed from a Zigbee Network through Coordinator or Hub Interface
From your ZigBee controller or hub interface, choose to delete or reset the
outlet as instructed. LED indicator of the outlet blinks 3 times to indicate
successful reset.
Note: Make sure both the device and remote are added to the same gateway that supports find and bind.
Zigbee
Remote
Step 3
: Set the remote or touch panel into Touch Reset procedure to reset the
device, please refer to corresponding remote or touch panel manual to learn how
.
Zigbee
Remote
Step 2
: Set the remote or touch panel (target node) into find and bind mode, and enable it
to find and bind initiator, please refer to corresponding remote or touch panel manual
.
Step 3
: There shall be indication on the remote or touch panel that it bind the device
successfully and can control it then
.
< 10cm
Step 2
: Bring the remote or touch panel within 10cm of the outlet
.
