Always shut off the scooter by turning the ignition switch to OFF.
When braking, always engage the rear brake first to retain maximum control
of the scooter. Most of your stopping power comes from the front wheel.
CAUTION:
Squeeze brake lever will shut off the motor, however leaving the ignition switch at the
ON position could drain the battery.
Shutting off the scooter
Always keep the key in the lock position when parking the scooter to prevent
theft. Park on smooth and hard surface,being sure to use the side stand
whenever possible.
The side stand is conbined with parking stop swith.The parking stop swith will
cut off the power of the motor while the side stand is released.
Parking
DANGER!
Wet, oily, or sandy roads reduce braking effectiveness. Hard braking on these surfaces
could lead to loss of control and a serious accident. Always reduce speed as gradually as possible.
Stopping the scooter
DESIGNED BY MIKU TEAM
DESIGNED BY MIKU TEAM
17/18
Motor safety
Keep the scooter free of dirt and
debris，especially in the throttle
linkage area.
Never start the engine or motor unless
you are property seated with your
hands firmly on the controls.
Make sure that all srews，locknuts，and bolts are
properly tightened.Never over-tighten
hardware that is designed to move.
restrictingmoving parts can cause
a loss ofcontrol and possible injury
or death.
Never tamper with，alter，or change the scooter
motor settings .The motor governor is factory
set and protects the motor from damage.
Excessive motor speed is potentially
dangerous to the operator by standers，
and the motor itself.
Operating the scooter in conditions where water,mud,snow,
dirt sand or other debris can get into the throttle wire conduit
and or the throttle mechanism can
cause the wire or throttle mechanism
to bind,which may lead to throttle
sticking,loss of control,and possible
death,injury,and or property damage.
Always replace torque-type locknuts with
new locknuts of the same type after
removing the old ones.
Fasteners
Ⅰ
Ⅱ
Ⅲ
巡航