Sunquest SQ 1000S, Инструкция по сборке и эксплуатации

Страница: 11 / 15

7
Care & Maintenance-Replacing Lamps
Replacing Lamps
Introduction
To be assured of maximum tanning effectiveness, change lamps after approximately
800-1000 hours of use. Tanning will continue after this time but at a slower rate.
Warning! Disconnect sun canopy electrical power before servicing.
Removing/Replacing Lamps
Step 1. To get access to the lamps the safety grill needs to be removed.
To do this, remove either one of the endcaps by unscrewing
the four screws that secure it. Carefully lift the endcap off the
canopy. The safety grill can now be slid out of the canopy.
Step 2. Grasp the lamp at one end and at the middle, then turn the
lamp 90 degrees. The lamp may then be gently removed from
its holder.
Step 3. To re-install a lamp, insert the pins located on the ends of the
lamp into the slots on top of the lamp holder and turn the
lamp 90 degrees.
Only the following lamp types have been certified for use in SunQuest Sun Canopies
Application Lamp Model Number
Canopy Velocity Wolff Model 71T12100W
Diamond Sun S Wolff Model 71T12100W