12
are & Maintenance
C
Cleaning After Use
Clean and disinfect your tanning bed’s bench and canopy after each use. Use a non-abra-
sive disinfectant cleaner that
does not contain ammonia or ammonia derivatives
.
Ammonia may damage the acrylic shield. Spray the acrylic lightly with disinfectant and
wipe dry with a clean soft cloth. We recommend
SunQuest
disinfectant and
SunQuest
acrylic cleaner.
Thorough Periodic Cleaning
Introduction
The cooling fans draw air through the bed and over time will cause a dust buildup on the
lamps and reflectors. This will reduce the tanning effectiveness of the bed. When a dust
buildup is observed, it is necessary to thoroughly clean the inside of the bench and
canopy.
Warning!
Disconnect sunbed from electrical power before cleaning.
Cleaning the Canopy and Bench
Step 1.
Remove the acrylic shields and lamps as described on page 13.
Step 2.
With a soft cloth, wipe the entire length of each lamp to
remove any film build-up.
Step 3.
Clean both sides of the acrylic shields with a non-ammonia
disinfectant cleaner.
Step 4.
Wipe the reflectors with a clean damp cloth.
Step 5.
Re-install the lamps and acrylic shields as described on pages 13-14.
Mechanical Inspection
Your tanning bed has been built for years of service. To ensure trouble free operation
throughout its life, inspect the unit’s mechanical integrity every 400-500 hours of use.
• Inspect the unit’s fasteners verifying that all are firmly in place. Pay particular attention
to the hinge bolts.
• Inspect gas springs for signs of wear. Gas springs that will not hold up the canopy
in the full open position should be immediately replaced.
• Inspect the timer as indicated in this manual under
Timer Maintenance
.
• Inspect the AC power cord and its connections.
• Inspect the acrylic. Broken, cracked or badly scratched acrylics should be replaced.
Содержание Pro 14SE
Страница 1: ...A S S E M B L Y A N D U S E R G U I D E M O D E L P R O 1 4 S E 21162A ...
Страница 22: ...NOTES ...
Страница 23: ...NOTES ...