SunnyBrook Mobile Scout Titan 2006, Руководство пользователя

Страница: 25 / 35

SAFETY REGULATION REGARDING PROPANE GAS SYSTEMS
AND PROPANE GAS APPLIANCES
The tank manufacturer has affixed the following labels to
the propane tanks and valves of this trailer:
NOTICE:
T
HIS IS A NEW CYLINDER THAT SHOULD BE
PURGED BY AN AUTHORIZED PROPANE FILLER
BEFORE IT IS FILLED FORTHE FIRST TIME. THE
FILLER WILL REMOVE THIS LABEL AFTER
PURGING AND FILLING . DO NOT OVERFILL.
WARNING!
- Only qualified persons are permitted to fill this cylinder
- Read and understand the cylinder warning label before
attempting to fill
- The Overfill Prevention Device (OPD) will only operate if
the cylinder is overfilled (greater than 80% level). Do not
attempt to calibrate or tamper with the OPD.
- Before filling, inspect the cylinder in accordance with CGA
C-6 or CGA C-6.3
- Cylinder must be level, stable and vertical at all times.
- This cylinder must be filled in accordance with US DOT,
NFPA-58, State and Local regulations.
- Failure to properly fill the cylinder can result in injury or
death.
The following label has been placed in the vehicle near
the range area:
24
A warning label has been locate near the propane
gas container. This label reads:
The manufacturer of this recreational vehicle is required
to furnish the following consumer information as provided
by the National Fire Prevention Association and the
American National Standards Institute. The information
and warnings found here may also be found in other
sections of this Owner’s Manual.
WARNING!
PROPANE GAS CONTAINERS SHALL NOT BE
PLACED OR STORED INSIDE THE VEHICLE.
PROPANE GAS CONTAINERS ARE EQUIPPED
WITH SAFETY DEVICES WHICH RELIEVE
EXCESSIVE PRESSURE BY DISCHARGING GAS
TO THE ATMOSPHERE.
This warning label has been located in the cooking area to
remind you to provide an adequate supply of fresh air for
combustion:
THIS CYLINDER IS EQUIPPED WITH AN
OVERFILL PREVENTION DEVICE
Propane gas regulators must always be installed with
the diaphragm vent facing downward. Regulators not
in compartments have been equipped with a protec-
tive cover. Make sure the regulator vent faces down-
ward and the cover is kept in place to minimize vent
blockage, which could result in excessive gas pres-
sure causing fire or explosion.