11. Operation example settings
Example: ZONE A control 1000W ballast, output power is
780W, sunrise time 08:35,(60% power), sunset time 9:00
(turn off), Sunrise and sunset duration time is 29min, if
ambient temperature is 30°C
≤
temperature
≤
40, dimming
down automatically to decrease power and temperature. If
temperature >40°C, turn off and enter into protection status.
12. Sun System
®
1 Etelligent
™
Controller technical parameters
Power
DC5V/2A
Match ballasts
600W and 1000W
Control command time interval
2S
Power Dimming Scope
600W: 40%-110% (240W-660W)
1000W: 60%-115% (600W-1150W)
Power regulation accuracy
1%
Temperature-controlled
adjustable inspection scope
32° - 104°F (0° - 40°C)
Temperature-controlled
protection inspection scope
50° - 122°F (10° - 50°C)
Sunrise and sunset duration
0-30 min
Turn on delay protection time
0min, 5min, 10min, 15min, 20min, 25min and 30min
13. Sun System
®
1 Etelligent
™
Controller TROUBLESHOOTING
Problem
Inspection method
Troubleshooting
Controller doesn’t have any
display after plugging in power
Check the power supply
Reset power supply
Check the adapter
Change to another adapter
Check the controller
Change to another controller
Fail to control ballasts
Check the connection of
controller and ballasts, make sure
each connection is good
Reconnect the wires
Controller doesn’t have any
temperature display after
temperature probe connected
Check if the temperature
probe is damaged
Change to another
temperature probe
Fail to turn on the lamp
Check the LED on the ballast to
ensure the LED indicator above
the out plug is flashing normally
Reconnect the wire
Ballast does not appear to
be functioning on desired
setting sent via controller
Check the sunrise and sunset
time setting
Reset sunrise or sunset time
Check the temperature probe
and temperature-controlled value
you selected
Change the temperature-
control value you set
When some ballasts are
not functioning properly
on a channel
Check if the connection
wire between ballasts is
functioning properly
Replace connection wire
or unplug and then plug
in again
Check the connection
of the power cable
Plug in and out to try again
Check if the ballast is
functioning properly
Check the LED on ballast
