Owner’s Manual — Sunlawn MM-1
7
1.
Turn the mower over to expose the cutting bar.
2.
Using a 10mm open end wrench, turn the hex bolt at one end of
the cutting bar until the cutting bar and cylinder come into contact.
Then back off the bolt about 1/8 turn, until the cutting bar and
cylinder are no longer in contact.
3.
Make the same adjustment at the other end of the cutting bar.
4.
Now check the adjustment using the small 0.05mm gauge (silver
strip) supplied with the MM-1 (or any 0.05mm feeler gauge). If the
gauge is held by the cylinder blades but the cylinder and cutting bar
are not touching then the adjustment is correct.
5.
The blades may also be tested by inserting a piece of paper
vertically into the blades while turning them by hand.
WARNING
Be careful of injury — handle the blades
carefully to avoid cutting yourself. Wear
appropriate gloves or hand protection.
!