Assembly Instructions
Step 1
Check all parts and hardware listed on the parts list. Lay them on a clear and level surface prior to
assembly. Ideally, the gazebo frame should be set up in its desired location to avoid moving it after assembly.
Step 2
Attach lintel (B) to screen (C) and fasten using bolt (J) and washer (G). Make sure not to cross-thread
bolts (see Fig. 1). Do not overtighten fasteners.
Step 3
Attach poles (D) to centre fitting (A) and fasten using bolt (F), washer (G) and nut (H) (see Fig.2).
Step 4
Attach poles (E) to centre fittings (A) and fasten using bolt (F), washer (G) and nut (H) (see Fig. 2).
Step 5
Attach poles (D) to screen (C) and fasten using bolt (
N
), washer (G) and nut (H) (see Fig. 3).
Step 6
Attach poles (E) to lintel (B) and fasten using bolt (
N
), washer (G) and nut (H) (see Fig. 3).
Step 7
Put canopy (K) over the frame, fit canopy corners to the top part of poles (D), and then fit canopy
rim onto the top part of poles (E).
Step 8
Tighten all hardware and put plastic nut caps (I) on nuts (H).
Step 9
Pull up the brackets (M).
Step 10
Secure the gazebo to the ground with stakes (L).
