16
iv) It is easier to saw a log using the spiked bumper
(Fig. 20D).
– Dig the spiked bumper into the log and use it as a
pivot. Cut with an arched motion to make the bar
penetrate the wood.
– Repeat several times if necessary, changing the point
where you plant the spiked bumper.
– When bucking on a slope, always stand on the uphill
side of the log (Fig. 21). When cutting through the
log, maintain control by releasing the cutting pressure
near the end of the cut without relaxing your grip on
the chain saw handles. Do not let the chain contact
the ground.
After completing the cut, wait for the saw chain to stop before
you move the chain saw. Always stop the motor before moving
from tree to tree.
Finishing Work
When you have finished your work:
• Switch off the motor and unplug the unit from the power
source.
• Wait for the chain to stop and allow the machine to cool.
• Remove any traces of sawdust or oil deposits from the
chain.
• If there is excessive dirt or resin build-up, disassemble the
chain and place it in a container with a suitable cleanser.
Then rinse it with clean water and treat it with a suitable
anticorrosive spray before reassembling it on the machine.
• Fit the cutting bar sheath onto the bar before storing.
m
WARNING!
Let the motor cool completely before
storing the chain saw in any enclosed space.
To reduce fire hazards, clean the machine thoroughly to
remove sawdust, branches, leaves, or excess grease.
Never leave containers with cut debris inside the storage area.
Maintenance
Please contact an authorized Snow Joe
®
+ Sun Joe
®
dealer
or call the Snow Joe
®
+ Sun Joe
®
customer service center
at 1-866-SNOWJOE (1-866-766-9563) for all maintenance
operations not foreseen in this manual. Any operation
performed in an unauthorized service center or by unqualified
personnel will completely invalidate the warranty.
m
WARNING!
For your safety and that of others:
•
Correct maintenance is essential to maintain the original
efficiency and safety of the machine over time.
•
Keep all nuts, bolts, and screws tight to be sure the
equipment is in safe working condition.
•
Never use the machine with worn or damaged parts.
Damaged parts are to be replaced and never repaired.
•
Only use original Snow Joe
®
+ Sun Joe
®
replacement
parts. Parts that are not of the same quality can seriously
damage the equipment, compromise safety, and invalidate
the warranty.
m
WARNING!
Always unplug the unit from the power
source before
performing any adjustments, maintenance,
or repairs to your electric chain saw..
• Use protective gloves when handling the bar and chain.
• Keep the protective cutting bar sheath on, except when
intervening directly on the bar or the chain.
• Never dispose of oils or other pollutants in unauthorized
places.
Motor Cooling
To avoid overheating and damage to the motor, always keep
the cooling air vents clean and free of sawdust and debris.
R
Fig. 20D
Spiked bumper
Spiked bumper
Fig. 21
