background image

2

• USE DUST MASK –

 Wear face or dust mask when  

operating this product.

• USE HEARING PROTECTION –

 Wear ear plugs or muffs 

when operating this product.

• GROUND FAULT CIRCUIT INTERRUPTER –

 (GFCI) 

protection should be provided on the circuit(s) or outlet(s) 
to be used for this product if you are using an extension 
cord. Receptacles are available having built-in GFCI 
protection and may be used.

• DOUBLE INSULATION – 

This product has double insula-

tion. This means that all external metal parts are insulated 
from the electrical supply. This is achieved by introducing 
an insulation layer between electrical and mechanical  
parts. The double insulation guarantees you the greatest  
possible safety.

• EXTENSION CORD –

 Make sure your extension cord is 

in good condition. Use only extension cords having an 
electrical rating not less than the rating of the product. An 
undersized extension cord will cause a drop in line voltage 
resulting in loss of power and overheating.

• POLARIZED PLUGS – 

To reduce the risk of electric 

shock, this product has a polarized plug (one blade is 
wider than the other). This product must be used with a 
suitable polarized extension cord. Polarized connections 
will fit together only one way. Make sure that the recep-
tacle end of the extension cord has large and small blade 
slot widths. If the plug does not fit fully into the extension 
cord, reverse the plug. If it still does not fit, obtain a 
suitable extension cord. Do not change the tool plug or 
extension cord in any way.

m

WARNING: 

Use outdoor extension cords 

marked SW-A, SOW-A, STW-A, STOW-A, SJW-A, 
SJTW-A, or SJTOWA. These cords are rated for outdoor 
use and reduce the risk of electric shock.

• 

DISCONNECT UNIT

 from the power supply when not in 

use or when servicing or cleaning. Do not leave unat-
tended.

• 

DON’T ABUSE CORD – 

Never carry or pull this product 

by the cord or yank the cord to disconnect from the 
receptacle. Keep cord from heat, oil, and sharp edges.

• 

STAY ALERT – 

Watch what you are doing. Use common 

sense. Do not operate the garden shredder when you are 
tired or under the influence of drugs or medication.

• 

STORE IDLE UNIT INDOORS – 

When not in use, the 

machine should be stored indoors in a dry and high or 
locked-up place, out of children’s reach.

• 

MAINTAIN UNIT WITH CARE – 

Keep clean for best 

performance and to reduce the risk of injury. Inspect 
extension cord periodically and replace if damaged. Keep 
handles dry, clean and free from oil and grease.

• CHECK FOR DAMAGED PARTS –

 Before further use of 

the product, any part that is damaged should be care-

fully checked to determine that it will operate properly 
and perform its intended function. Check for alignment 
of moving parts, binding of moving parts, breakage of 
parts, mounting and any other condition that may affect 
its operation. Any part that is damaged should be properly 
repaired or replaced. Call our customer service help line 
for assistance at 1-866-766-9563 for assistance.

• 

LIGHTING – 

Only operate your machine in daylight or 

good artificial light.

• 

DON’T OVERREACH –

 Keep proper footing and balance 

at all times. Wear oil resistant rubbersoled footwear.

• Never leave a running tool unattended. Turn the machine 

OFF and wait until it comes to a complete stop before 
leaving the work area.

• Avoid accidental start-ups. Make sure switch is in OFF 

position before plugging in the power cord.

• 

USE RIGHT APPLIANCE –

 Do not use this product for 

any job except that for which it is intended.

• 

KEEP CHILDREN AWAY –

 All visitors, children and pets 

should stay at a safe distance from the work area.

m

WARNING:

 

Some dust and debris created by 

the use of this tool could contain chemicals known to the 
State of California to cause cancer and birth defects or other 
reproductive harm.

Some examples of these chemicals are: 
- chemicals in fertilizers 
- compounds in insecticides, herbicides and pesticides 
- arsenic and chromium from chemically treated lumber

Your risk from exposure to these chemicals varies 
depending on how often you do this type of work. To   
reduce your exposure, work in a well-ventilated area and 
with approved safety equipment, such as dust masks that 
are specifically designed to filter out microscopic particles.

m

WARNING:

 

The wires of this product could 

contain chemicals know to the State of California to cause 
cancer and birth defects or reproductive harm. Wash hands 
after handling.

Electrical Safety

1. 

Always check that the power supply corresponds to the 
voltage on the rating plate.

2. 

Do not operate in an area where there is a possibility 
of body contact with grounded items (i.e.: pipes, metal 
structures). Avoid contact with metal objects.

3. 

Do not pull/yank the power cord. Keep the power cord 
away from hot surfaces and sharp objects.

4. 

Always use a grounded three-wire extension cord and 
receptacle that are made of rubber and intended for 

Содержание AJ800E













Отзывы: