sunfun Elba 28883674, Руководство пользователя

Страница: 37 / 85

15
22 - Setting the extension/retraction distance
The motor has already been pre-set at the factory. Major settings are therefore not
required before it is used. However, the motor needs to be readjusted in the following
cases:
- The awning does not extend fully
-
The awning does not retract fully
- The awning fabric sags
- The motor continues to run although the awning is already fully closed

Turn the red adjusting screw clockwise in direction [+] to increase the
extension distance.

Turn the red adjusting screw counter-clockwise in direction [-] to reduce the
extension distance.

Turn the white adjusting screw clockwise in direction [+] to increase the
retraction distance.

Turn the white adjusting screw counter-clockwise in direction [-] to reduce
the retraction distance.
The awning fabric stretches over time through the permanent spring tension, which means that
the retraction distance has to be corrected.
External influences, such as moisture or heat, can have an impact on the awning
fabric to such an extent that the retraction distance needs to be readjusted.
Note: Wait approx. 30 minutes if the motor does not work after adjusting it
several times and then restart it.
Do not overload the motor. Otherwise the service life of the engine can be
shortened.
23
– Operating the awning manually
The built-in motor has a manual crank function, but this may only be used to retract
the awning in an emergency, e.g. in the event of a power failure.
It is not suitable for continuous operation; this can lead to serious damage to
the awning!
-
Remove the side cover on the left-hand side (motor side), see point 18, Fitting
the side covers