18
Under
Board and Sensor Alignment
, you can set the orientation of the arrow of the flight
control SF RACING F3. The
arrow
of our board points to 90 degrees clockwise from the plane
head orientation, or if you take the front of the plane, it points to your right. Therefore, set
–90
for
Yaw Degrees
. Place the flight control with the arrow at the position of 90 degrees anti-
clockwise from the aircraft head, and set
90
for
Yaw Degrees
; place it with the arrow right at
the head, set it as
0
.
After setting, click
Save and Reboot
to save it.
2.3.3
Receiver
The
SF RACING F3
supports PPM, SBUS, and DSM/DSMX; thus you can set your receiver to these
modes.
PPM Signal Mode
The receiver is set under the PPM signal mode originally. Under this mode, the least serial ports are
occupied and the LED indicator can be set. Here
PPM
is set as the default RX signal input in
Betaflight. So if your receiver is in the
PPM
signal mode, there is no need to change the setting of
Receiver Mode
in Betaflight.
SBUS Signal Mode
1)
If your receiver is in the
SBUS
signal mode, click
Ports
on the left and activate
Serial
RX
in
UART3
, and then click
Save and Reboot
.
SunFounder
