Scenario 5 - T-Max® Manager Series with wires
As always, this tanning booth is fully compatible with a wired T-Max®
system. Simply connect the RJ-22 modular cable(s), described in the
TMax® Manager manual, into the remote port(s) located on the Control
Unit and follow the instructions that came with your remote system.
Scenario 6 - Single Booth wired to T-Max® 3A
In single sunbed installations, the T-Max® 1A and 3A can offer the
same control as the T-Max® Manager, eliminating the need for a Man-
ager. If you’re using a 1A in this manner, it must have a chip labelled
“master” installed on its circuit board. The remote control bypass plug
must not be used in this configuration. The 3A may be used as a “mas
-
ter” with no modification.
After you have set the T-Max® 1A’s, or 3A’s, address to “0” (refer to
your T-Max® user’s guide) and the booth’s address to “1”, simply con-
nect the RJ-22 modular cables, described in the T-Max® user’s guide,
directly into either of the smaller ports located on the Control Unit and
either port on the back of the T-Max® 1A or 3A.
Scenario 7 - Non T-Max® Remote System wired to unit
Most non-T-Max® remote systems control the sunbed by the use of a
relay. The relay operates the sunbed by connecting and disconnecting
a pair of wires leading from the sunbed. Refer to the user’s manual pro-
vided with your remote system to determine if it operates in this way.
To connect your booth to this type of system a remote interface kit is
required. Contact your place of purchase to obtain the kit. The illustration
below details a typical connection. Follow the instructions provided with
the kit and from the remote’s manual to make the necessary connections.
Setting the address manually
Before connecting your booth to the T-Max® Manager or T-Max® 1A or
3A, the address of your booth must first be set. Set the address manually
as described below.
Setting the Address
1
Make sure the display is showing “0”.
2
Press the red stop button and, without releasing it, press the green
timer button and hold both for three seconds. The display should
indicate an address number from “1” to “255”.
3
If you are using a T-Max® 1A or 3A as a “master” remote, the ad-
dress of the booth must be set to “1”. If you are using a TMax® Man-
ager each sunbed must be assigned a different address. To adjust the
address, press the green timer button to count up until the desired
number (from 1 to 128) is achieved. Addresses 252 to 255 are not
normally used.
4
Press the red stop button to return to the normal display mode.
1-99
100-128
(blinking dot)
252-255
(blinking dot)
Using Your Booth
Before using your booth, please note the following:
• Your skin should be free of cosmetics, tanning oils, or other body
lotions prior to tanning except for those specifically made for use
with tanning devices. However, do not remove natural body oils by
bathing or showering immediately before tanning.
• Keep treated hair from contacting booth surfaces. Many hair prod-
ucts can damage the booth acrylic. Wear a shower cap or towel if
you use gels, mousses, sprays, or other hair products.
• Your booth is designed for individual use. Always wear the safety
goggles supplied with your booth or another approved pair of gog-
gles, as defined under 21 CFR 1040.20. Regular sunglasses do not
provide adequate protection from ultraviolet light.
Follow the guidelines for skin type and exposure times as shown in the
table below. Untanned persons should not tan on consecutive days
during their first week of tanning. Never tan more than once a day. Tan
-
ning normally appears after the first few sessions and maximizes after
approximately four weeks. Tan once or twice per week thereafter to
maintain appearance. Persons already having a base tan may begin at
advanced levels corresponding to the extent of their base tan.
Skin Type:
I Sensitive Skin (Burns easily and severely and does not tan.)
II Light Skin
(Burns easily and severely and tans minimally.)
III Normal Skin (Burns moderately and tans average.)
IV Dark Skin
(Burns minimally, tans easily and above average.)
5
RECOMMENDED EXPOSURE TIMES IN MINUTES
Level 1/Week 1
Level 2
Level 3
Level 4
Level 5
Skin Type:
1st-3rd Sessions
I Sensitive
NOT RECOMMENDED FOR TANNING
II Light
2
4
6
8
10
III Normal
3
5
7
10
10
IV Dark
4
6
8
10
10
MAXIMUM EXPOSURE TIME IS 10 MINUTES
