The appliance is supplied with an installation kit including adhesive sealing material and fixing
brackets&screws are included with the appliance.
• Cut the aperture dimensions as indicated in Figure - 6. Locate the aperture on the worktop such
that after the hob is installed the following reguirements are ensured;
Figure 6
Neighbourhood walls
Combustible
Non-combustible
*If your appliance have five hobs ;
Min. A
60 mm
40 mm
Min. B
150 mm
50/100* mm
60 cm Built-in Hobs
70 cm Built-in Hobs
C
580 mm
700 mm
B
A
c
t
t>20 mm
Carefully trim away the excess sealing
material “C” from around the appliance.
•
Figure 7
Apply the adhesive sealing material “C” all the way
round the aperture on the worktop to match the
outher perimeter edge of the appliance. Ensure that
the junctions overlap at the corners and no gap is left
along the sealing material.
Insert the appliance into the aperture and fix in
position via the brackets (A) and screws (B).
Adjust the position of the brackets depending
on the thickness of the worktop as indicated in
Figure7 and tighten the screws evenly.
•
•
C
515mm
490mm
Min. A
Min. B
560mm
42 mm
9
