90025A & 9002B:
Parts Breakdown & Operating Manual
rev. 04/4/06
Never mount oil and water extractor on or near the air compressor.
During compression, air temperature is greatly increased. As the air cools down to room temperature, moisture condenses in the air line, on
its way to the spray gun. Therefore, always mount the oil and water extractor at a point in the air supply system where the compressed air
temperature is lowest.
Drain air lines properly.
Pitch all air lines back towards the compressor so that condensed moisture will flow back into the air receiver where it can be drained off. Each
low point in an air line acts as a water trap. Such points should be fitted with an easily accessible drain. See diagram above.
Length of Pipe (ft.)
Air
Flow
CFM
50
100
150
200
10
20
30
40
50
70
1/2"
3/4"
3/4"
1"
1"
1"
3/4"
3/4"
3/4"
1"
1"
1"
3/4"
1"
1"
1"
1-1/4"
3/4"
3/4"
1"
1"
1"
1-1/4"
This spray gun is rugged in construction, and is built to yield exceptional value. The life of this product and the efficiency of its
operation depend upon a knowledge of its construction, use and maintenance.
GRAVITY FEED HOOKUP
Air pressure for atomization is regulated at
extractor. Amount of fluid is adjusted by fluid control
screw on gun, viscosity of paint, and
air pressure.
AIR SUPPLy
Oil & Water
Extractor
Drain
Oil and Water Extractor should be at least 5 ft.
from the compressor, farther if possible.
25 Feet
or More
Install drain at
each low point
Compressor Unit
Pitch pipe back
toward air receiver
Drain
TyPES OF INSTALLATION
Gravity
Feed
Cup
Fluid Control Screw
Air Inlet
Air Hose
Atomization
Pressure
Gauge
Oil and
Water
Extractor
