Sundown Audio P-PRO 180, Руководство оператора

Страница: 14 / 40

14
5.3 DRIVELINE INSTALLATION
Before using the PTO shaft, please consult the use and maintenance manual attached to the pto
shaft.
In case that the PTO shaft, supplied with the machine, is not used, please check that the cowlings of the
machines and of tractors are overlapped to the PTO shaft’s shield of 5 cm., at least.
For a correct and safe operation of the machine, please use exclusively PTO shafts with CE mark.
Please use PTO shafts with integral shields.
• Grease periodically, the PTO shaft following the instruction supplied by the PTO shaft manufacturer
(see the use and maintenance manual of the PTO shaft).
• Observe the sense of assembly of the PTO shaft, as indicated by the manufacturer and shown on the
outer cover of the shield (tractor drawing on the external tube of the PTO shaft towards the power take-off of
the same tractor).
• Fasten the safety ant-rotation chains and make sure that the safety anti- removing block (push
connecting ring nut) is correctly placed and blocked in the right lodging.
ATTENTION!
Check the rotation sense and the speed
regulation of the power take-off of the tractor to
be at 540 rpm, as the machine is projected for
this kind of speed.
The length of the PTO shaft must be adapted to the type of used tractor.
When the PTO shaft is released from the power take-off of the tractor must ALWAYS be laid on the
appropriate support.
THE MANUFACTURER IS NOT RESPONSIBLE FOR THE DAMAGES CAUSED BY AN INCORRECT ASSEMBLY
AND USE OF THE PTO SHAFT.