Sundown Audio P-PRO 180, Руководство оператора

Страница: 13 / 40

13
i = Tractor wheelbase (cm)
d = Distance between front axle and ballast center of mass (cm)
T = Weight of t operator (75 kg)
Z = Ballast weight (kg)
M = Spreader roller weight (if included) (kg)
s = Distance between rear axle and implement center of mass
5.2 CONNECTION TO THE 3-POINT HITCH OF THE TRACTOR
ATTENTION!
Every time that somebody comes down from the tractor, it is necessary to
disconnect the PTO shaft, stopping the engine and to put on the parking
brake.
For the connection of the machine to the tractor, please operate in the following way:
• Step backwards with the tractor until arriving in proximity of the lower connections of the SALT spreader.
• Fix the lower connections of the tractor to the pins of the machine and lock them with the safety plugs.
• Connect the upper linkage of the machine to the 3-point hitch of the tractor putting the appropriate pin and
block the anti-unscrewing device of the 3-point hitch;
• Raise the machine of some centimetres by the ground and operate on the lateral ties of the lifter bars and
on the two turnbuckles, in order to block the lateral movement, so as to prevent excessive oscillations during
the working phase.
The machine must be positioned, through the raising of the lower connections of the tractor, so that the land
distance from the lower extremity of the distributor disc is approximately of 70 cm. To obtain
a regular distribution, it is important that the distributor disc is in horizontal position compared to the land.
• After having made these operations, the PTO shaft must be linked to the splined shaft of the
gearbox of the machine (covered by a safety cowling) and after to the tractor power take-off.
ATTENTION!
The PTO shaft must always be connected to at last to the power take off and
disconnected at first, when you stop working.