Sundirect Stone600-Pro, Инструкция по установке и эксплуатации

Страница: 9 / 20

4.9.2 Connect to WIFI:
Step1: Turn on the power of the heater by pressing the “Power” button. The WIFI signal will start to
flash rapidly. Open the APP on your smartphone and add your device. Choose “Add Device”, then
“Add Manually”, and then choose “Thermostat” to add the device.
Step2: Enter the WIFI password of your home network. Please make sure your home WIFI is working
and keep the heater and smartphone as close as possible to the WIFI router.
Please notice that this heater is only working with 2.4GHz WIFI networks, it doesn’t support 5GHz
networks currently. Also, make sure your internet router has enough capacity to add a new device.
Step3: Wait till the connection status shows 100% to finish the settings and the WIFI signal on the
control box will stop flashing.
If the heater failed to connect, please power off the heater and power it back on again after a few
seconds. Long press the “WIFI” button on the control box until the WIFI sign on the screen is
flashing slowly and repeat the connection process.
5. Technical Specifications
Panels covered by these instructions are listed in the table below.
Model Power Voltage Size Mounting Remote
controller IP
Protection
Stone600-
Pro 600W 220-240V
~50Hz 55*110cm Wall Yes IP44
9