User Manual
_______________________________________________________________________________
SunComm Technologies Co., Ltd.
6
follows:
Making sure that all devices powered in the buildings are in accordance with NEC (National
Electric Code, National Electrical Regulations) Article 250 of manual properly grounded;
Making sure that the panel of building power supply units used high-quality copper wire well
connect with the ground wire, copper wire specifications shall comply with NEC Table 250-94/95
relevant provisions of the manual. Grounding cable that buried in the building field, including at
least one or several 2.44m deep under the ground, or buried deeply underground at least 0.76m,
with a wire around the building (see NEC manual specifications the relevant provisions of the
table 250-94/95);
Setting up voltage protector between equipment and ground connected to some other computer
equipments (either directly or through other devices), such as terminal or printer must also be
plugged into the same surge protector.
Network interface of SC-1695i supports RJ45 standard with 10Mbps or 100Mbps network.
Wireless section, inserting SIM card directly, GSM channel should work properly.
2.2 Installation Procedure
2.2.1 Install SIM Card
When installing SIM card, opening blank panel of SIM slot, procedure shows as below:
1)
Pull out the GSM user board
2)
Inset the SIM card to the SIM slot
3)
Push in the GSM user board
3. Network Configuration
In this chapter we will introduce the initial configuration of SC-1695i. All of the network
parameters of the gateway can be configured by IVR guidance.
3.1 Attentions
In each step, if user hears an IVR message of “setting successful”, which means that user has
finished this step successfully. However, if user hears a “setting failed” message, please check
redo theat step again.
