Installation Instructions
SB-WM46
7
Installing Interface Brackets to Display
1.
Place display face down on a soft, non-abrasive surface.
2.
(If applicable) Remove four sets of bolts and washers that
were shipped attached to the back of the display. (See
Figure 4)
Figure 4
3.
Place two interface brackets (D or E) on the back of the
display, with the indented brackets facing toward the inside
of the television. (See Figure 5) or (See Figure 6)
NOTE:
Use short brackets (D) if installing to 46" or 55" models
and long interface brackets (E) if installing to 65"
models. (See Figure 5) or (See Figure 6)
NOTE:
Spacers (AL and AM) are used to offset the bracket if
the mounting holes are recessed or to get around the
protrusions.
4.
Secure the interface brackets (D or E) to the display. Select
the mounting hardware that fits your application. (See
Figure 5) or (See Figure 6)
•
Use spacers (AL and AM), if necessary.
•
Use M6 screws (AC or AD) or M8 screws (AA and AB)
and 1/4" washers (AP).
•
Or, use M4 screws (AE, AJ or AK) or M5 screws (AF,
AG or AH), 1/4" washers (AP) and #10 washers (AN).
Figure 5
Figure 6
Install Faceplate Brackets to Faceplate
1.
Align faceplate brackets (B or C) with faceplate (Z) and slide
into position. (See Figure 7)
NOTE:
Use short faceplate brackets (B) if installing to 46" or
55" models and long faceplate brackets (C) if installing
to 65" models. (See Figure 7)
Figure 7
2
x 4
4
(AA-AK) x 4
(AL or AM) x 4
(if necessary)
(D) x 2
(46" or 55" models)
(AN) x 4
(w/M4 and M5
screws ONLY)
(AP) x 4
4
(AA-AK) x 4
(AN) x 4
(AL or AM) x 4
(if necessary)
(w/M4 and M5
screws ONLY)
(AP) x 4
(E) x 2
(65" models)
1
(B) x 2
(Z)
1
(Z)
(C) x 2
(46" or 55" models)
(65" models)
