Page 8
TV Installation – Rear Panel Internal Connect Source
WARNING: Do not connect the power source before making connections.
Internal Connect Source
The Internal Connect Source allows you to easily connect to the Audio, Video, S-Video, SVGA, HDMI, Audio Out, RF, RS232, and 12
VDC connectors, and the IR emitter window. The Internal Connect Source is inside the Cable Cover located on the back of the unit
(Figure 1).
1. Unscrew the three gray Thumb Screws (Figure 1), and pull the cover towards you.
2. Route the cables to the proper inputs, and place the cable cords over the Rubber Sealing Gasket (Figure 2).
Note: There is an Indentation on the Rubber Sealing Gasket (on the bottom portion of the right and left sides). Make sure cable
cords
are not placed on the Indentation.
3. Close the cover.
4. Press firmly on the cover, and screw the Thumb Screws tightly (Figure 3).
Rear Panel Connections
Figure 1
Figure 2
Figure 3
DO NOT place the
cables over these
Indentations in
the corners of the
cable door.
Place the cables over the
Rubber Sealing Gasket on
the side of the cable door.
Thumb Screws