SunBox SunLight Plus™ Bulb Replacement
REMINDER TO REPLACE YOUR BULBS
Because bulbs lose intensity with use and continued use of old fluorescent bulbs can damage the ballast, we recommend
that you change your bulb frequently. Do not wait until your bulbs burn out to replace them! *To maintain the warranty, you
must
replace the bulbs every three (3) years
. Failure to do so will void the warranty regardless of use. You can place an
order online 24 hours a day from our website:
If, for any reason, you encounter problems with your light box, contact us at 800-548-3968 or 240-651-3286
Limited Warranty/Guarantee:
The SunBox® Company, Inc. (us, we, our) warrants to the original purchaser (you, your) that the SunBox® SunLight
Plus® (light unit, unit) is to be free from defects in material and workmanship under
*normal use and service
for the lifetime of the unit. Our entire
liability and your exclusive remedy as to the unit(s) shall be repair or replacement of the unit, at our option, when returned to us with a copy of the
receipt. You shall be responsible for the cost of returning the unit to us with a copy of the receipt and $25 return shipping. If failure of the unit has
resulted from accident, abuse, or misapplication, we shall have no responsibility to replace or repair the unit. Fluorescent tubes are guaranteed for
one years against failure.(Shipping cost subject to change)
The above are the only warranties of any kind, either express or implied, including but not limited to the implied warranties of merchantability and
fitness for a particular purpose, that are made by The SunBox® Company on this product. No oral or written information or advice given by The
SunBox® Company, its dealers, distributors, agents, or employees shall create a warranty or in any way increase the scope of this warranty. This
warranty gives you specific legal rights. You may have other rights, which vary from state to state.
Specifications: 120V AC 50/60Hz .53 amps 55 watts
Dimensions:
14.5” H x 7” L x 6” D
Weight: 3.5 lbs.
Replace bulb with FML55
Made in USA
Rev. 12/21
(a)
(b)
(c)
1.
Unplug the unit.
2.
Place the SunLight Plus
™ vertically on a table or desk, so
that the cord is near the bottom and the unit is resting on a
triangular end with the rubber feet. Using a #2 Phillips head
screwdriver, remove the 3 screws that hold the top
triangular end piece in place, then remove the piece
(a)
.
3.
Laying the SunLight Plus™ on the long side, remove the 2
screws
(b)
.
4.
Gently slide out the inside assembly to gain access to the
light bulb
(c).
The shell and the unit are attached together
and will not separate due to the power cord wiring so be
careful when sliding out the unit.
5.
Gently remove the diffuser and place in a safe spot to
protect from any scratches.
6.
If you have a zip tie holding the bulb in place, remove the
zip tie. It was used for shipping purposes.
7.
Slowly pull the end of the old fluorescent tube furthest from
the socket outward at a 20º angle. If the bulb is broken, be
very careful not to cut yourself.
8.
Pull out the old bulb clip and replace with new bulb clip.
9.
At a 20° angle, insert the new bulb in its socket and gently
press the bulb into the bulb clip.
10.
Lay the diffuser back on the unit with the rough textured
side facing out. Slide the unit back into the shell.
11.
Screw in the 3 back screws from step 2.
12.
Place the triangle top and screw the 3 screws in from step
1.
13.
Plug in and enjoy!
