5
7. PREPARATION OF THE MICROWAVE
•
Open the bottom of the carton, remove microwave, all packing materials, Installation Instructions,
Wall Template, Top Template and Charcoal Filter; however, DO NOT REMOVE THE
WAVEGUIDE COVER, which is located on the ceiling in the microwave cavity.
•
CHECK THE MICROWAVE for any damage, such as misaligned or bent door, damaged door
seals and sealing surfaces, bent or loose door hinges and latches and dents inside the cavity or on
the door. If there is any damage, do not operate the microwave and contact your dealer.
•
Remove and save Screw (A) as shown in Figure 5.
•
Push down carefully on the tabs (B) and (C) at the ends of the Louver to disengage it. Pull the
Louver away from the unit and set aside.
•
Loosen the two Mounting Screws (D) which lock the Mounting Plate to the rear side of the
microwave. Remove the Mounting Plate. See Figure 6.
控制面板
(B)
(C)
(A)
图
5
边
图
6
(D)
(D)
后安装板
后安装板
Back installation plate
Back installation plate
Control
board
edge
Fig. 7
(A)
图
8
⑦
⑧
(D)
Fig. 5
Fig. 6
Fig. 8
