2
Notes:
•
Please read all instructions thoroughly before installing the microwave.
•
Two people are recommended to install this product.
•
If a new electrical outlet is required, its installation should be finished by a qualified
electrician before the microwave is installed.
1. MOUNTING SPACE
This microwave requires a mounting space on a wall
as shown in Figure 1. It is designed to be used with
standard 12- inch wall cabinets.
If the space between the wall cabinets is 36 or 42
inches, a Filler Panel Kit can be used to fill the gap.
The metal filler panels come in pairs, each either 3 or
6 inches wide. The Filler Panel Kit should be installed
before the microwave is installed.
2. WALL CONSTRUCTION
This microwave should be mounted against and supported by a flat vertical wall. The wall must be flat
for proper installation. If the wall is not flat, use spacers to fill in the gaps. Wall construction should be a
minimum of 2” × 4” wood studding and 3/8” or thicker dry wall or plaster/lath. The mounting surfaces
must be capable of supporting weight of 110 pounds---the microwave and contents---and the weight of all
items which would normally be stored in the top cabinet above the unit.
The unit should be attached to a minimum of one 2” × 4” wall stud.
To find the location of the studs, one of the following methods may be used:
1.
Use a stud finder, a magnetic device which locates the nails in the stud.
2.
Use a hammer to tap lightly across the mounting surface to find a solid sound. This will indicate
stud location.
The center of the stud can be located by probing the wall with a small nail to find the edge of the stud and
then placing a mark halfway between the edges. The center of any adjacent studs will normally be 16 or
24 inches to either side of this mark.
距地面至
少
180cm
图
1
距炉灶至
少
90cm
76cm
39cm
30cm
至少
40cm
At least 36”
At least 16”
At least 71”
from ground
Fig. 1
