Using your Cordless Filter Kettle.
Before using your kettle.
It is recommended that you clean your kettle
before use by boiling a full kettle of water then
discarding the water.
Using your kettle
1. To fill the kettle, remove it from the power
base and lift the lid. Fill with the desired
amount of water. Alternatively, the kettle
may be filled through the spout.
Always fill the kettle between the minimum
and maximum marks. Too little water will
result in the kettle switching off before the
water has boiled. Too much water may cause
it to spill out of the spout when boiling.
Ensure that the lid is firmly in place before
placing the kettle on the power base.
2. Connect the 3 pin plug into a 230-240 volt AC
power outlet. Turn the power ON.
3. Position the kettle on the power base. Press
the ON/OFF button. The power indicator light
will light up. The kettle will switch off
automatically once the water has boiled.
NOTE: Ensure that the ON/OFF switch is clear
of obstructions and the lid is firmly closed.
The kettle will not turn off if the switch is
constrained or if the lid is left open.
4. Lift the kettle from the power base and pour
the water.
NOTE: Use caution when pouring the water
from your kettle, as boiling water will scald.
5. The kettle may be stored on the power base
when not in use. The kettle will not re-boil
until the ON/OFF switch is pressed downward.
NOTE: Ensure the power is turned OFF while
the kettle is not in use.
Should you accidentally allow the kettle to
operate without water, the boil-dry protection
will automatically switch it off. If this should
occur, allow the kettle to cool before filling with
cold water and re-boiling.
Cord Storage Facility
Excess cord can be stored by feeding the cord into
the storage cavity underneath the power base.
Sunbeam’s 3 Way Safety System.
Safety is a major consideration in the design of a
Sunbeam kettle. That is why we have developed
our 3 Way Safety System, which ensures that
your kettle will:
1. Automatically switch off after boiling.
For convenience, safety and energy efficiency,
your Sunbeam kettle features an auto cut-out
device.
2. Cut-out for boil-dry protection.
If the kettle is operated without water, it will
automatically cut-out, preventing any damage
to the element.
3. Shut-down in case of overheating.
In the event of overheating, the kettle will
automatically shut down to prevent further
damage. Should this occur, take your kettle to a
Sunbeam Service Centre or Appointed Service
Agent.
