Sunbeam HC2900, Инструкция пользователя

Страница: 9 / 12

Oiling the Blades
The blades of your Hair Cutter should be
oiled before and after each use. Place a
few drops of oil on the teeth of the blades.
Only use the oil supplied with your Hair
Cutter. If the blades are not cleaned
and oiled regularly, or if you do not use
sufficient oil, the blades will begin to wear
and become blunt. This may result in hair
catching between the blades, which may
cause discomfort.
Make sure that the cutter is switched
off and unplugged from the power outlet
before cleaning.
Use the cleaning brush to remove hair and
clippings from the comb guides, scissors
and blades.
To Clean the Blades
To thoroughly clean the blades, remove the
screws and remove the blades from the
cutter. Wipe them over and replace on the
unit.
To realign blades:
1. Place a few drops of oil on the blades, plug
the cutter in and turn the power on. Turn
the cutter on for a few seconds.
2. Unplug the cutter and slightly loosen the
screws on the base of the blade.
3. Slide the blades back and forth until the
tips of both blades are aligned, tighten the
screws.
To Clean the Cutter
Wipe the outside of the cutter with a soft
dry cloth.
DO NOT IMMERSE ANY PART OF THIS
APPLIANCE IN WATER OR ANY OTHER
LIQUID.
Care and Cleaning
Help Line
If you have any additional questions about using your Hair Cutting Set, please call the Sunbeam
help line in Australia on 1300 881 861. In New Zealand please call 0800 786 232.