Sunbeam EM5900 Artista, Инструкция пользователя

Страница: 26 / 36

Scale is a surface build up of minerals that
naturally occur over time in all appliances
that are involved with the heating of water.
Therefore the espresso machine will require
occasional descaling. It is recommended
that the espresso machine is decaled every
4-6 months, this will vary depending on the
frequency of use and water hardness.
Descaling solution
Use any of the following when descaling the
espresso machine:

Sunbeam Espresso Machine Descaling
Tablets (EM0010)

Sunbeam Liquid Descaler (KEO100), or

Vinegar Solution.
Descaling the espresso machine
Note: Ensure the espresso machine is turned
off and the power cord is unplugged.
1. Remove the water reservoir and rinse clean.
Depending on the descaling solution being
used use one of the following:
A. Sunbeam Espresso Machine Descaling
Tablets
Fill the water reservoir with 1 litre of warm
water and place a descaling tablet into the
reservoir. Once the tablet has dissolved
replace the reservoir, this takes about 5-7
minutes.
B. Sunbeam Liquid Descaler
Fill the water reservoir with approximately
1.5 litres of water, add 1 capful of
Sunbeam Liquid Descaler and replace the
reservoir.
C. Vinegar solution
Fill the water reservoir with approximately
1.5 litres of warm water, add 3 tablespoons
of vinegar and replace the reservoir.
2. Should the group handle be attached to
the group head remove it, rinse thoroughly
under running water and set aside.
3. Using a screwdriver unscrew the brewing
filter/shower screen from the underside of
the group head.
4. Remove and set aside the filter/screen,
washer and screw in a safe place.
Important: Be careful not to lose the filter/
screen, washer and screw once you have
disassembled the group head.
5. Using a small brush scrub in and around
the area at the brewing head, removing all
coffee grinds.
6. Place a sufficiently large container under
the group head.
7. Insert the power cord into a 230-240V AC
power outlet and switch the power ‘ON’.
Press the ‘POWER’ button once to turn the
espresso machine on.
Note: Check to see that the espresso machine
is ready for use (see p7 Ready Mode).
Remember if the ‘POWER’ light is flashing
green this indicates that the espresso
machine is on and is heating up.
8. Press the 'COFFEE' button and allow half
the solution to cycle through the group
head and then once again press the
'COFFEE' button to stop the flow.
Important: Do not run descaling solution
through the steam wand.
Note: Depending on the size of the container
under the group head on occasion this may
need to be emptied throughout this process.
9. After half the solution has cycled through
press the 'COFFEE' button to stop the
flow and then press the ‘POWER’ button
to turn the machine off.
Descaling
24