![background image](http://html1.mh-extra.com/html/sunbeam/em3820/em3820_user-manual_1393608020.webp)
18
Descaling
16. After 1 minute, stop the machine by
turning the operating dial to the off (
)
position.
17. Leave the machine off for 10-15 minutes
to allow the descaler to take effect.
18. Turn the dial to the espresso (
)
setting
and allow ½ of the rest of the descaler
solution to run through the brewing head.
19. Turn the dial to the steam (
)
position.
Place the steam wand over the drip tray.
20. Allow the hot water to run through the
wand for 2 minutes. Return the dial to the
off (
) position.
21. Turn the dial to the espresso (
)
setting
and allow the remaining solution in the
water reservoir to run through the group
head.
22. Remove the water reservoir from the
machine and rinse thoroughly under
running water, ensuring that all traces of
the descaling solution is removed. Fill the
water reservoir with clean water and place
onto the machine.
23. Run two (2) full water reservoirs through
the group head. Refill the water reservoir
and run the steam nozzle for 4-5 minutes.
Note: Ensure that you continue to run water
through the machine until the water runs clean
and clear.
24. When this is finished, remove the water
reservoir and set aside. Remove the water
containers and give the machine a good
wipe over.
25. Turn the machine upside down. The
machine should now be on the warming
plate resting on the cloth/tea towel once
again.
Important: The group head will be hot from
the descaling process. Allow this to cool down
before replacing any parts.
26. Carefully replace the rubber seal, filter,
washer and screw. Tighten well.
27. Turn the machine upright, so that it is now
sitting correctly on the bench.
28. Replace the drip tray.
29. Fill the water reservoir with water and
position it on to the machine.