FINAL ART 5/5/05
& Associates, Inc.
Job # 0023671 Size:10.75" x 8.25" (PAGE 5.375" x 8.25") Art Built @ 100% PAGE SIZE Colors: B/W
5
Control Features
Features:
• 3 TEMPERATURE SETTINGS – select your personal comfort level
• SILENT OPERATION – no clicking when adjusting the temperature
• SOLID STATE – for accurate and consistent heat control
• EASY OPERATION – electronic control for easy operation
• EASY GRIP – ergonomic control for easy operation
• AUTO-OFF (SlimStyle AO only) – 3 hour Auto-Off
(see page 2)
Using Your Warming Throw Control:
1
To turn the throw on simply press the round gray button. The indicator
light will glow, depending on which setting the warming throw is set,
and the warming throw will begin to warm.
CAUTION:
ALWAYS turn the warming throw “OFF” and disconnect
the power cord from the outlet when not in use.
2
To turn the warming throw OFF simply press the round gray button
through the different settings until the temperature setting lights are
not glowing.
Module
Control
Power
Cord
Flag Tag
Throw Cord
Connector
Throw Cord
Label
SlimStyle
™
AO
(Auto-Off)
A85AP
SlimStyle
™
A85P
When setting up your warming throw, be sure to follow the steps below in order.
1
Locate the warming throw’s information label near the module.
2
Make sure the cord is connected into the module at the bottom of the
warming throw until the plastic hinges click into place.
CAUTION:
Cord must be COMPLETELY CONNECTED. A risk of fire could result
from a loose connection.
Warming Throw Set Up
For questions or support, please visit:
www.sunbeam.com
2
1
3
3
Plug the warming throw power cord into a 110-120 volt wall outlet.
CAUTION:
Do not plug main power cord into the wall outlet until you have completely
set up your warming product per the instructions.
• Disconnect power cord from wall before detaching control from warming product.
• Always make sure cords are NOT trapped or pinched between bed slats, mattress,
springs, against wall, foot board or bed frame, or between furniture, walls or chairs.
CAUTION:
Do not attempt to force the plug. This appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of electrical shock, this plug is intended to fit only one way into an outlet. If
the plug does not fit in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
IMPORTANT
2
If there is a flashing light on
your control, see page 8.
