Waiting on Front
Cover from Energi
Waiting on Front
Cover from Energi
7
6
Temperature Setting Guide
Note:
The temperature settings are a guide only and may require adjustment to suit various
foods and individual tastes. When the dial is set to a MIN setting, it is quite normal for
food to stop and start bubbling, as the thermostat maintains the selected temperature.
The settings on the dial represent the following temperatures approximately.
Pre-heat your frypan on MAX setting then change to your desired setting.
DIAL
SETTING
CELCIUS
(approx)
USES
TEMPERATURE
MIN
50°C - 70°C
Keeping food warm
LOW
MIN/MED
80°C - 105°C
Simmering, slow cooking
MED
120°C - 140°C
Pan frying
MEDIUM
MED/MAX
150°C - 175°C
Shallow frying, roasting
MAX
190°C - 210°C
Searing and sealing
HIGH
Care & Cleaning
Use heat-resistant plastic or wooden or
silicone utensils when cooking on the frypan.
Avoid using sharp or metal objects as these
will scratch the non-stick surface. Do not cut
food on top of the cooking surface. Do not
leave plastic utensils om contact with the
cooking surface while in use.
To clean after use
Always turn the power off and remove the
plug from the power outlet and the control
probe from the probe inlet before cleaning.
Allow the frypan to cool before cleaning.
DiamondForce™ non-stick coating
When cleaning with the DiamondForce™
non-stick coating, do not use metal (or other
abrasrive scourer). When the frypan have
cooled down, you may wipe using a paper
towel to remove residue on the frypan .
With the control probe detached, wash with
warm soapy water using a mild household
detergent. Rinse thoroughly and dry the
frypan with a soft cloth before storing. Make
sure the interior of the probe inlet is fully dry.
Heat Control probe
If cleaning is necessary, wipe over with a
damp cloth.
Note: The control probe must be removed
before the frypan is cleaned and the control
probe inlet must be dried before the frypan is
used again.
Important: Do not immerse the control probe
in water or any other liquid. Store the crontrol
probe carefully. Do not knock or drop it as this
can damage the probe.
Storage
Store the control probe carefully in a safe
place. Do not knock or drop it as this can
damage the probe.
If damage is suspected, return the control
probe to your nearest Sunbeam Service
Centre for inspection.
Glass lid
Wash the lid in warm soapy water using
a soft sponge, rinse and dry thoroughly.
Alternatively, wash the lid in a dishwasher.
