Sunbeam ChoicePlus 85KQP, Руководство пользователя

Страница: 12 / 29

8
For questions or support, please visit: www.sunbeam.com
Q My heated blanket/heated mattress pad/warming throw doesn’t heat properly.
A Your heated product is not a heating pad. It will not feel hot to the touch when laid out flat in a
normal manner. Try the following fold test to see if it is operating properly:
1 Fold the heated blanket, heated mattress pad or warming throw 3 times
over.
2 Make sure the control cord is connected to the module and then plug the
power cord into an outlet.
3 Turn on your heated product, then turn the control to the highest setting
and wait 5 to 7 minutes.
4 Put your hand between the folds and you should feel the blanket/ mattress
pad/throw warming up.
Caution: DO NOT continue the test for more than 7 minutes. DO NOT attempt to make any internal
adjustments to this appliance. If you have tried all of the
solutions above and the heated product still doesn’t work, stop using it immediately,
disconnect the power cord and contact Sunbeam Consumer Care.
Q What does “FF”, “F1” or “F2” mean on my Electronic Digital Control?
A
The digital controls are designed to notify you in the event that a problem has been discovered by
flashing “FF”, “F1” or “F2” on the display.
Models: SmartSense
™
, ChoicePlus
™
, StyleSmart
™
Follow instructions below.
Models: SelectTouch
™
, ComfortSet
™
Follow instructions below.
Models: SelectTouch
™
, ComfortSet
™
Follow instructions below.
1.) Follow the instructions on the flag tag attached to the control cord to reset control.
2.) Check the blanket/mattress pad for visual damage.
3.) If no visual damage is found, unplug the system from wall outlet.
4.) Check that the control is well-connected to the module.
5.) Plug the power cord into the wall outlet.
6.) Set the control to “On”.
7.) If the system does not operate after 2 or 3 times trying to reset, disconnect the power cord and
contact Sunbeam Consumer Care.
Q What does a flashing light mean on my EasySet™, PrimeStyle™, PrimeStyle™ AO or
EliteStyle™ control?
A
These controls are designed to notify you in the event that a problem has been discovered by flashing
the light on the control. Follow instructions on the flag tag to reset control. First, check the heated
product for visual damage. If no visual damage is found, unplug the system from wall outlet. Check
that the control is well-connected to the module. Plug the power cord into the wall outlet and turn the
control On. If the product still does not operate after 2 or 3 times trying to reset, disconnect the power
cord and contact Sunbeam Consumer Care.
FF
F1
F2