Sunbeam 7621, Инструкция по эксплуатации

Страница: 8 / 14

Measurements
1. Attach the
arm
cuff to the left arm as described
in Na 2 on page 12.
2. Turn Power ON
l
When power is turned ON, all display marks appear for
approximate1
1 s e c o n d .
When the “
t h e
" is displayed the unit is ready for measurement, If
mar appears, release air with the exhaust valve pushbut-
ton until the " appears,
Approx.
1 second
3, Pressurize the arm cuff by pumping the bulb until you have a read-
ing of approximately 30 to 40 mmHg higher than your usual blood
pressure range. NOTE: Cuff may become slightly tighter than the cuff
used in a Doctor’s office. A beeper will sound when pressure reaches
160,200, 240 and 280 mmHg.
4,
When
pressurization
is completed, the automatic exhaust mechanism
will gradually reduce arm cuff pressure, and the mark will appear
on the display indicating that measurement
Pressure value appearson
is in progress.
the, left, and, exhaust speed on the right
side display. . . i .,.:, . . . .
. .
Current Pressure xhaus’t Speed
( g r a d u a l l y b e i n g r e d u c e d )
Measurement Mark
Accurate measurement cannot be taken when exhaust speed is
o u t s i d e t h e 2 - 5 mmHg r a n g e S e e p a g e 1 3 .
R e m a i n s t i l l d u r i n g m e a s u r e m e n t .
When a pulse is detected, the pressure value moves to the right
side of the display. At this time the mark flashes at the same
14
rate as pulse rate, and the beeper sounds.