![background image](http://html.mh-extra.com/html/sunbeam/4059-015/4059-015_instruction-manual_1394088003.webp)
SAVE THESE INSTRUCTIONS
FOR PRODUCTS PURCHASED IN THE U.S. AND CANADA ONLY
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade is wider than
the other). This plug fits a polarized outlet only one way; if the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this
safety feature.
◆
4
IMPORTANT SAFEGUARDS
When using your flatiron, basic safety precautions should always be followed, including
the following:
READ ALL INSTRUCTIONS BEFORE USING
1.
Use iron only for its intended use.
2.
To protect against risk of electric shock, do not immerse the iron in water or other liquids.
3.
The iron should always be turned to “OFF” before plugging or unplugging from outlet.
Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
4.
Do not allow cord to touch hot surfaces. Let iron cool completely before putting away.
Retract cord into cord reel when storing.
5.
Always disconnect iron from electrical outlet when filling with water or emptying and when
not in use.
6.
Do not operate iron with a damaged cord or if the iron has been dropped or damaged.
To avoid the risk of electric shock, do not disassemble the iron. Take it to a qualified
serviceman for examination and repair. Incorrect reassembly can cause a risk of electric
shock when the iron is used.
7.
Close supervision is necessary for any appliance being used by or near children.
Do not leave iron unattended while connected or on an ironing board.
8.
Burns can occur from touching hot metal parts, hot water or steam. Use caution when
you turn a steam iron upside down — there may be hot water in the reservoir.
9.
If the flatiron is not operating normally, disconnect from the power supply and have the
flatiron serviced by qualified service personnel.
10. Your Sunbeam
®
Iron is designed to rest on the heel rest. Do not leave the iron unattended.
Do not set the iron on an unprotected surface, even if it is on its heel rest.
11. This is a 1200 Watt appliance
*
To avoid a circuit overload, do not operate another high
wattage appliance on the same circuit.
12. If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords rated
for less amperage may overheat. Care should be taken to arrange the cord so that it cannot
be pulled or tripped over.
◆
3
*In Mexico, the iron runs at 127 Volts, 1350 Watts. If an extension cord is necessary, a 13 ampere cord should be used.
Содержание 4059-015
Страница 26: ...NOTES NOTAS 28 NOTES NOTAS 27 ...
Страница 27: ...NOTES NOTAS 28 NOTES NOTAS 27 ...