Heating mode:
M
ANUAL
/R
EMOTE
O
PERATION
:
1.
Press the ON/OFF button at the top of the unit, the heater will switch ON and the fan will blow. The COOL AIR
indicator will illuminate
2.
Press the MODE button, to operate at 1000W. The 1000W indicator will illuminate.
3.
If more heat is required press the MODE button again, to operate at 2000W. The 2000W indicator will
illuminate.
4.
Press the OSC button, to start oscillation. The “OSC” indicator will light up. To stop the swing function,
press the OSC button again - the indicator light should be no longer illuminated.
5.
To switch the heater OFF at anytime, press the ON/OFF button until the “COOL AIR” indicator light flashes. The fan
heater will continue to operate for 10 -15 sec, and then it will switch OFF.
NOTE: Always remember to turn the unit off by the On/Off button at the base of the unit.
Timer function:
The timer function allows the fan heater to operate continuously at 30 minute intervals, and can be programmed up to 7.5 hours
before it automatically turns OFF. This applies for both Manual and Remote operation.
1.
Press the TIME button once for 30min operation before the unit will automatically turn itself OFF.
2.
Press the TIME button again for 1 hour etc. Repeat this process until the desired time of operation is achieved.
3.
The time indicators will light up depending on the time chosen. For example, if the timer is programmed to operate for
5.5 hours, the indicator 4h, 1h, and 0.5h will be illuminated on the control panel.
4.
To cancel the timer function. Press the TIME button until all indicators lights are OFF.
Overheat Protection:
Your heater is fitted with a safety device that switches the heater off, should the unit overheat or tip over, it will switch off
automatically. If this should occur, all you need to do is:
•
Disconnect the plug from the electrical socket and wait at least 30 minutes before plugging it back in.
•
Ensure the heater is not covered and nothing is obstructing any of the vents.
•
Plug the heater back into the electrical socket and switch the heater on.
•
If the problem persists and the safety device switches off the heater again, return the heater to the place of
purchase.
•
If the heater has tipped over, repeat the above instructions and ensure the heater is positioned on a level surface.
B
ATTERY
The remote control uses 2 x AAA batteries. We recommend lithium type batteries for longer use.
Please dispose of batteries as per instructions on the battery packaging.
H
INTS
/
TIPS TO RETAIN THE HEAT IN YOUR HOME
•
Do not overheat your home, in winter the temperature of a heated room should be between 18-21°C
•
Choose the right size heater for the room that you wish to heat.
•
Zone off the unoccupied rooms by closing doors, and curtains to limit heat loss.
•
Use draft stoppers where possible, to keep the cold air from filtering in under doors.
•
Avoid placing items, or sitting too close to the heater for optimal air flow.