sun valley MSDVBP, Руководство владельца по эксплуатации и установке

Страница: 7 / 38

7 106021
OWNER’S MANUAL
INSTALLING DIRECT-VENT
BURNER SYSTEM INTO
STOVE BODY
1. Attach the two brackets to the back of
the stove (see Figure 17). Use the
screws and washers from step 4 of
Stove Body Assembly on page 5.
2. Carefully lift burner system and place
into stove body from the rear of stove.
3. Using screws provided, attach burner
system to brackets on back of stove (see
Figure 17).
Figure 17 - Installing Burner System Into
Cast Iron Stove Body
L O
H
I
P
IL O
T
OFF
ON
Cast Iron
Stove Body
Screw
Burner
System
17. Replace the two screws from step 15,
page 6, to reassemble the front plate and
the front surround plate. Set this assem-
bly aside until burner system has been
installed, logs have been placed inside
of burner system, and glass door to
burner system insert has been replaced.
18. Remove the four screws that secure the
metal plate located across the front sec-
tion at the top of the stove body (see
Figure 16). Discard these screws and
metal plate. They are for vent-free use
only.
19. Set three grate sections into stove top.
CAST IRON STOVE
AND DIRECT-VENT
BURNER SYSTEM
ASSEMBLY
Continued
Figure 16 - Removing Metal Plate from
Stove Body
Bracket
Screw
Stove Body
Metal
Plate
INSTALLING OPTIONAL
BLOWER ACCESSORY
NOTICE: If installing blower in an
existing stove burner system with
gas connections, shut off gas sup-
ply and disconnect burner sys-
tem from gas supply. Contact a
qualified service person to do this.
Attaching Thermal Switch to
DA3610T Thermostatically-
Controlled Blower
When installing the DA3610T thermostati-
cally-controlled blower accessory, you must
first secure the thermal switch to the blower.
1. Remove the two hex head screws on the
blower assembly as shown in Figure 18.
2. Place the green wire between the bot-
tom hole on the thermal switch bracket
and the bottom hole on the blower as-
sembly. Insert one of the hex screws
into all three pieces and tighten.
3. Insert the top screw through the ther-
mal switch bracket and into the blower
assembly. Tighten screw.
4. Connect the blue wire on the blower
assembly to the right side of the ther-
mal switch.
5. Connect the black wire to the left side
of the thermal switch.
Figure 18 - Attaching Thermal Switch to
DA3610T Thermostatically-Controlled
Blower Accessory
Thermal
Switch
with
Bracket
Black
Wire
White Wire
Green
Wire
Blue Wire
Hex Head
Screws
Blower
Assembly
Continued
Screw
with
Washers