Vacation Time:
During long absences, remove all contents. Unplug the appliance, clean it, and
leave the doors open slightly to avoid possible formation of condensation,
mold, or odors.
Moving Your Appliance:
1.
Remove the contents.
2.
Securely tape down all loose items inside your unit.
3.
Turn the leveling legs up to the base to avoid damage.
4.
Tape the doors shut.
5.
Be sure the appliance stays secure in the upright position during
transportation.
Energy Saving Tips:
•
The unit should be located in the coolest area of the room, away from
heat-producing appliances or heating ducts and out of direct sunlight.
•
Try not to open the doors too often, especially when the weather is damp
and hot. Once you open a door, close it as soon as possible.
•
Occasionally check if the appliance is sufficiently ventilated (adequate air
circulation behind the appliance).
•
Set the thermostat from higher to lower settings as soon as (depends on
how loaded the appliance is, ambient temperature, etc.).
•
Before loading items into the unit, be sure they have cooled to ambient
temperature.
•
A layer of frost and ice increases energy consumption, so defrost the
freezer as soon as the layer is ½" thick.
Reversing the Door Swing:
If you find the direction of opening the doors of the appliance inconvenient,
you can change it. Holes on the opposite side have already been prepared at
the factory.
This appliance can be opened from either the right side or the left. By default,
the door hinges are on the right side. If you prefer them on the left, please
follow these instructions and refer to the illustration on the following page.
NOTE: All parts removed must be saved to do the re-installation of the doors.
1.
Remove the hinge on the right top of the cabinet.
2.
Remove the four bolts and washers (using a ratchet tool with a phillips
head/tip) that holds the top hinge to the cabinet. Keep these for later use.
Technical Information
Model Number
ST-16RF
Color
White / Gray
Capacity
16 cu. ft.
Electrical Input
12/24 V DC
Rated Current
5 amp
Energy Consumption
0.6 kw @ 24 hrs.
Refrigerant
R134a
Installation
Free-standing
Ship Weight
270 lbs.
Unit Dimensions (w x d x h)
31" x 34.0" x 68"
Flash number
Fault Occurring
1
Battery protection cut out
2
Fan over-current cut out
3
Motor start error
4
Minimum motor speed error
5
Thermal cut out of module
Installation Instructions
Before Using Your Appliance:
•
Remove the exterior and interior packing.
•
Before connecting the unit to a power source, let it stand for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system
from handling during transportation.
•
Remove the shelves and clean them and the interior surfaces of the unit with
lukewarm water using a soft cloth.
Installing the Refrigerator/Freezer:
•
Place the unit on a floor that is strong enough to support the appliance when it
is fully loaded. To level the unit, adjust the two leveling legs at the front
•
Model ST-16RF is designed to be free-standing only, and should not be
recessed or built in. When installing, allow at least 3 inches of space at the top,
sides, and rear of the unit, which will allow the proper air circulation to cool the
compressor and condenser.
•
Locate the unit away from direct sunlight and sources of heat (oven, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources
may increase electrical consumption.
•
Avoid locating the unit in moist areas. Too much moisture in the air will cause
frost to form quickly on the evaporator, requiring more frequent defrosting of
the unit.
Page 5
Page 2
Содержание Model ST-16RF
Страница 1: ...Model ST 16RF Owner s Manual...
