Sun Oracle Fire X4470, Руководство по установке

Страница: 33 / 76

Chapter 3 Installing Windows Server 2008 23
Note – Windows Server 2008 enforces stronger password schemes for user accounts.
Password standards include restrictions on length, complexity, and history. For more
details, click the Accessibility link at the account creation page.
After the initial user account is created, the Windows Server 2008 desktop
appears.
13. Proceed to Chapter 4 to perform the post installation tasks.
Windows Server Installation Using a
PXE Network Boot
This section explains the initial information you will need to install the Windows
Server 2008 (SP2 or R2) operating system over an established PXE-based network
using a customer-provided Windows Imaging Format (WIM) image.
Topics included in this section:
■
“Before You Begin” on page 23
■
“Install Windows Server 2008 (SP2 or R2) Using PXE Network Boot” on page 24
Note that the procedure presented in this section documents the initial steps to
install Windows Server 2008 over the network using a Windows Deployment
Services (WDS). Specifically, it explains the steps for selecting the server PXE
network interface card that will communicate with your WDS installation server. For
further information about using WDS to install the Windows Server 2008 operating
system, see Microsoft’s Windows Deployment Services documentation.
Before You Begin
■
To use PXE to boot the installation media over the network, you must:
■
Configure the network (NFS, FTP, HTTP) server to export the installation tree.
■
Configure the files on the TFTP server that are necessary for PXE booting.
■
Configure the server’s MAC network port address to boot from the PXE
configuration.
■
Configure Dynamic Host Configuration Protocol (DHCP).
■
To use WDS to perform the installation, you must:
■
Add the required system device drivers to the
install.wim
image and, if
necessary, the
boot.wim
image.