Sun Microsystems x4422a, Руководство пользователя

Страница: 27 / 96

Chapter 2 Installing the Adapter 9
8. Applying even pressure at both corners of the adapter, push the PCI adapter until
it is firmly seated in the slot.
Caution –
Do not use excessive force when installing the adapter into the PCI slot.
You may damage the adapter’s PCI connector. If the adapter does not seat properly
when you apply even pressure, remove the adapter and carefully reinstall it again.
9. Secure the adapter to the PCI slot using the screw you removed in Step 6.
10. Detach the wrist strap and close the system unit.
11. Connect the SCSI cables.
12. Connect the Ethernet cables.
a. Connect one end of the Ethernet cable to the port on the card.
b. Connect the other end of the Ethernet cable to an active Ethernet network.
▼
To Verify the Installation
After you have installed the Sun Dual Gigabit Ethernet and Dual SCSI/P adapter,
but before you boot your system, perform the following tasks to verify the
installation. Refer to the your Solaris documentation for the detailed instructions.
Note –
Verification is not required if your system supports dynamic reconfiguration
(DR).
1. Power on the system, and when the banner appears, press the Stop-A key
sequence to interrupt the boot process and display the OpenBoot (
ok
) prompt.