Sun Microsystems SunSwift SPARCserver 1000, Руководство пользователя

Страница: 28 / 76

2-8 SPARCserver 1000 System Board Manual—October 1994
2
2.4.1.1 SuperSPARC Module A
Warning – The heatsinks on the SuperSPARC modules may be hot. Use
caution when removing or installing SuperSPARC modules and avoid contact
with the heatsinks. Hold SuperSPARC modules only by the edges.
1. Unlock the four standoffs that secure the module to the system board.
Pull up the tip insert of each standoff to unlock. Refer to Figure 2-3.
2. Hold the SuperSPARC module by the edges near the connector and
carefully rock the module back and forth to loosen the connector from the
socket.
Caution – The connector housing will break if the module is tilted too far.
3. Place the module in an antistatic bag.
2.4.1.2 SuperSPARC Module B
Warning – The heatsinks on the SuperSPARC modules may be hot. Use
caution when removing or installing SuperSPARC modules and avoid contact
with the heatsinks. Hold SuperSPARC modules only by the edges.
1. To unlock the SuperSPARC module, pull up the tips of the two standoffs.
Pull up the tip insert of a standoff to unlock it.
2. Hold the module by the edges near the connector and gently rock the
module back and forth to loosen it from the socket.
3. Lift the module from the socket at an angle while guiding the other side
of the module out from the back panel filler.
The special SuperSPARC module back panel filler is shown in Figure 2-5.
Each of the module holes rests on a small pin. The module must be rocked
back and forth gently to free it from the back panel filler.
Note – It may be necessary to remove either SuperSPARC module A or the
SBus card in slot 1 to get a firm grip on module B. A firm grip is necessary to
remove the module from the connector without breaking the connector.
!